HSS-R, type N, roll-milled, DIN 338, black
Cylindrical, short, right, standard , sharpening angle 118°. Suitable for steel, cast iron alloyed and unalloyed ( lower as 900 N/ mm²), grey and pressure casting, sintered iron, graphite, short-chip aluminium alloys, suitable for brass and bronze

HSS-TIN, type N, titanium coating, DIN 338
cylindrical, short, right, sharpened, titanium coating, from Ø 3mm cross-grinding, sharpening angle: 135°. Suitable for steel, cast steel alloyed and unalloyed ( lower as 900 N/mm²), grey and die-cast, sintered iron, graphite, short-chipping aluminum alloys, brass and bronze

HSS-CO, type N, with 5% cobalt, DIN 338
Cylindrical, short, right, polished, tips from 3mm split point, sharpening angle 135°. Suitable for alloyed and unalloyed steels (700 - 1300 N/ mm²),hot and cold work steels, tempering and case-hardening steels and stainless and acid resistant steels

DIN388, HSS M2, cylindrical, short, cross-ground, step drill tip geometry, 3-flute shank from 4.0 mm
High-precision, high-performance spiral drill for universal use on smooth, rounded and uneven surfaces. Ideally suited for use in hand-held machines, e.g. cordless screwdrivers and electric drills, as well as pillar drills. The drills eliminate the need for pre-drilling, enable precise spot drilling without running, as well as angled drilling and are very good for drilling out rivets and stud bolts.

for non-ferrous metals, plastic, plasters, suitable for Micromot systems
Wolfram-vanadium steel. For use on hard and soft woods, non-ferrous and precious metals, as well as plastics and plasters. Shaft Ø 2,35 or 3,0mm. Especially suitable for finishing, forming, profiling and grooves.

glass processing, 4 pieces, with arbor, shaft Ø 2,35mm, suitable for Micromot systems
For engraving, grinding or frosting glass. Industry and dentalquality. Silicon carbide bits and diamond bits. 2x bullet form (silicone carbide), 2x ball form (diamond).

HSS, 10 pieces, similar to DIN 338, suitable for Micromot systems
For drilling non-ferrous metal, steel and stainless steel. Industry and dentalquality
Content: each 1 x Ø 0,3 - 0,5 - 0,8 - 1 - 1,2 - 1,5 - 2 - 2,5 - 3 - 3,2mm

HSS-CO, for the exact drilling of spot welds, DIN 1897, with special tips

HSS, for cutting spot-welded metal parts

set, diamond, shaft Ø 2,35mm, suitable for Micromot systems
for drilling holes in semi-precious stones, gems etc. industry and dental quality