scissor jack, mechanic
Stable steel design, with large and wide foot surface, smooth spindle and hand rotary-handle

for garage jack, protects the lifting point

robust, fully welded steel design

hydraulic, cast steel foot, two-pieces pump lever
detachable sleeve of the oil reservoir, hardened steel piston, cold drawn extension with thread, cast steel adapter (saddle), can be used in horizontal position, then the stroke is reduced

hydraulic, for general lifting requirements
A handy foot pedal allows fast lifting without loads, the extra-wide wheels provide a solid footing and stability under load

for jack
protects the support point

hydraulic, flat intake height
Robust, fully welded steel construction with special lowering system. Pressure relief valve prevents overloading. Quick-approach foot pedal. Lowering control valve for safe lowering. Low-noise plastic wheels

Attention: The Jack is only intended to lift a load and not to support. Please only work on and under raised vehicles if they are secured with axle stands against tipping over, rolling off or slipping down. May only be used on level and firm ground and not driven under load.

High jack, hydraulic, for lifting vehicles
Robust, fully welded steel construction with special lowering system, quick lift by foot pedal, safety valve to control the lowering process. With ergonomically shaped, rubber-covered grips for improved operating comfort.

Note: The jack is only intended to lift a load and not to support it. Work may only be carried out on and under lifted vehicles if they are secured against tipping over, rolling and sliding and supported with safety stands. May only be used on level and firm ground and may not be driven under load.

hydraulic, for vehicles
small, compact, with detachable pump lever for easy transport and foot pedal for fast aproach

suitable for Tesla models 3 / S / X / Y, 4 pieces
Suitable for rubber pads with 120-140mm outer diameter. It is suitable for use on lifting platforms and jacks and is made of high-strength and dimensionally stable special POM (polyoxymethylene) plastic to prevent damage due to bouncing. A circumferential gripping groove facilitates disassembly after lowering.

Note from the manufacturer: Mandatory when lifting Tesla Model 3, S, X and Y. Without using these adapters, there is a risk of damaging the battery box or even the battery. The adapters are inserted into the locating hole under the vehicle and aligned over the existing rubber plate from the support arm of the lift or jack.