front or rear attachment, yellow lens

for turn signal, with screw

front, lateral or rear attachment, with 2 M4 mounting screws

front attachment, yellow lens, dimensions: 60 x 90 x 55mm, 2 for M5 mounting screws, screw distance: 42mm

for turn signals with LED function, 12 / 24V
for monitoring of LED turn signals, simulation of a 21W bulb by power resistor, voltage consumption: 12 or 24 VDC, power consumption (12/ 24 VDC): 1,75A (21W)/0,875A (21W), electric connection: 300mm (cable with open cable ends), attachment: 2 screws (ST 6,5), hole distance: 59mm, dimensions: 87 x 73 x 29,5mm

front, lateral or rear attachment, black plastic housing, hole screw M10 x 1 for the attachment

ballast for turn signals with LED function, 5-pin
Application with all Aspöck tail lights without integrated LCG. Adjusts the electrical characteristics of LED lights to the needs of tractors that are not yet LED compatible. Monitors the turn signal function according to legal regulations (current adjustment and failure control as well as overcurrent switch-off).
Note: Only compatible with Aspöck LED taillights! One LCG is required for each indicator function (without an integrated LCG). This means that two LCGs are required per vehicle. When using more than one rear light per vehicle side, the LCG may only be connected to one LED rear light.