REINHEIMER balance weights
Adhesive weight bar, steel, black, pack of 100 pcs.
Flat design (3.8 mm), with premium adhesive tapes, powder-coated
REINHEIMER balance weights "The all-rounder"
Standard, for steel rims, zinc
Universal weight suitable for most steel rims. Fine zinc alloy with elastic poly coating. The use of weight pliers with plastic impact part is recommended.
REINHEIMER balance weights
Adhesive weight bar, for light alloy rims, steel
Flat design (3.8 mm), with elastic poly coating.
REINHEIMER rubber valves
For tubeless car Tires (Snap-In), Pk. à 100 pcs.
REINHEIMER valve cap
package unit: 100 pieces
metal valve cap, VG8, gas-tight
brass nickel-plated, with flat silicone ring seal
- Article number: 43204791
- Original number: 071312
key cap, VG8 (valve cap with valve insert screw)
brass nickel-plated, with a cup gasket made of silicone
- Article number: 43207737
- Original number: 071310
REINHEIMER Valve Insert "C1-9002"
3 pieces, brass nickel-plated, with red seal ring for high operating temperatures
Due to the design, this special insert is suitable for a large number of valve types and also for special valves. For trucks, cars and motorcycles, opening pressure higher as 4,5 bar, working pressure lower as 20 bar, temperature range: - 60°C - 200°C
REINHEIMER balance weights
Standard, for light alloy rims, zinc
Universal weight for use on rims with normal rim flange.
SERWO AUTOMOTIVE Wheel Bolt Bag
cotton, bag with double strap, 150 x 200mm
REINHEIMER rubber valves
Manufactured to DIN 7780, with gas-tight metal Valve Ccps
Can be used for tubeless tires on cars and motorcycles up to a maximum speed of 210 km/h. Maximum permissible deflection angle 25°. If this is not guaranteed by the wheel cap or other supports, the rubber valves must not be installed. In such cases, we recommend using metal valves.
Technical data:
Material: Rubber
Rim hole Ø: 11.3 mm
Length: 33 mm
Working pressure (max.): 4.5 bar
Axial pull-in torque (max.): 600 Nm
REINHEIMER Rubber Valve
snap-in, HP valve for transporter and caravans with tire pressure >5,5 bar
With continuous support tube made of brass into the rubber foot and an integrated safety support plate under the valve foot. Can be used up to a maximum material thickness of the rim of 1,8 - 3,0mm. This special construction makes it possible to fill the tires with an air pressure of up to 9 bar. The valve is an alternative if, for technical, constructional or other reasons, a metal valve can not be used.
Note: Prerequisite for the use of such valves, is a standard rim hole and a flat bearing surface on the inside of the rim for the valve foot, so that a secure seal is possible.
