very slim design, straight steel wire, with hole to hang
For remove of stubborn brale dust, suitable for tightly brake caliper surfaces

For easy adjusting the idle mixture adjusting screw at the carburettor. The wrench can be used also for other, hard-to-reach screws

Technical data:
cassette total dimensions (LxWxH): 110 x 550 x 45mm

The set contains following articles:
angled screwdriver, length: 470mm
length: 365mm (without handle)
handle - length: 112mm
adapter slotted - 5mm, length: 9,5mm, 90° angled
quick-change adapter 90° angled
carburator special socket - D-type, length: 25mm
Phillips - 2mm, length: 19mm
Phillips - 2mm, length: 42mm
slot - 5 mm, length: 19mm
slot - 5 mm, length: 42mm
slot - 5 mm, length: 78mm

Note:
The offset screwdriver set can not be used for tight screws because the bevel gear could be damaged under high loads!

1/4", fine toothed with 72 teeth, 5° actuation angle, with locking and release mechanism, with curved shaft to protect against injury, plastic coating, DIN 3122 / ISO 3315. Material: hardened steel

3/8", fine toothed with 72 teeth, 5° actuation angle, with locking and release mechanism, with curved shaft to protect against injury, plastic coating, DIN 3122 / ISO 3315. Material: hardened steel

1/2", fine toothed with 72 teeth, 5° actuation angle, with locking and release mechanism, with curved shaft to protect against injury, plastic coating, DIN 3122 / ISO 3315. Material: hardened steel

with plastic blade,ideally for removing e.g. stickers and seals. The plastic blade does not damage sensitive or painted surfaces. 2-component handle, total length: 280mm, blade length: 135mm

For installation and removing of springs e.g. in exhaust, brake shoe and stand. With T-handle, total length: 165mm, shaft length: 150mm, hook form (90° double angled)

For easy installation and removal of pipe springs, e.g. at the exhaust, brake shoe and stand. With T-handle, total length: 210mm, shaft length: 195mm, hook form (45° angled)

for removing and installing of snap rings, grips with non-slip plastic coating, tip Ø: 1mm, material: hardened steel

for removing and installing of snap rings, grips with non-slip plastic coating, tip Ø: 1mm, material: hardened steel