CONDOR bit "16033"
star, 1/4", outside hexagon drive, length: 25mm
HAZET bit set "2223N"
1/4", star profile, 6-point drive, length: 25mm, 3 pieces
specially hardened material, optimized torsion zone, for manual and machine operation (also for impact wrenches), colour coding on the bit, hexagon drive ISO 1173 C6.3 (1/4″)
WERA bit "IP TORX PLUS"
star, 1/4", 6-point drive, without hole, extra hard, length: 25mm
For inside star Plus screws. Suitable for Bosch, Fein, Holz-Her, Lecreux, Metabo. High torques are transmitted through the Torx Plus profile. Compared to the "normal" Torx profile, the enlargement of the 6 torque transmitting flanks between tool and screw is realized by an elliptical and not circular profile design. This distributes the force applied when screwing over larger areas and additionally increases the service life of the screw and tool. Suitable for holders according to DIN ISO 1173-D 6,3
WERA bits "IPR TORX PLUS®"
IPR profile, 1/4", hexagon drive, with hole, extra hard, length 25 mm
A 5-flank TORX PLUS® profile with hole. Tough and hard, for universal use. This drive geometry has been reduced by one flank and drilled to protect safety screw connections from unwanted loosening. These Screws cannot be operated with standard commercially available tools. Suitable for brackets to DIN ISO 1173-D 6.3.
KS-TOOLS bit "Classic"
star, 10mm external hexagon drive, length: 30mm
for manual, electric and impact screwdriver, suitable for screw connections in trade and industry, reinforced design, sand blasted, special steel, nickel-plated
KS-TOOLS bit "Classic"
star, 10mm external hexagon drive, length: 75mm
for manual, electric and impact screwdriver, suitable for screw connections in trade and industry, reinforced design, sand blasted, special steel, nickel-plated
CONDOR bit "18033"
star, 10mm ouside hexagon drive, length: 30mm
for manual operation, electric or impact wrench, chrome-vanadium steel, applicable in craft and industry.
HAZET bit "2223-T"
1/4",star profile, hexagon drive, length: 25mm
special steel, for electric and pneumatic screwdrivers as well as for manual operation. Hard for threaded screws (hard screw-joint), permanent hardness of 59 - 61 HR C for high demands in trade and industry, ISO 1173-C 6,3 (1/4")
KS-TOOLS bit "Classic"
star, 10mm external hexagon drive, with hole, length: 30mm
for manual, electric and impact screwdriver, reinforced design, special steel, sand blasted, nickel-plated
KS-TOOLS bit "Plus"
star, 10mm outside hexagon drive, length: 30mm
for manual operation, electric and impact wrenches, suitable for fittings in crafts and industry, reinforced design, sandblasted, special steel, nickel-plated, DIN 3126, ISO 1173 - C 8
