1/2", with adjustable angle pin as fixed point
Range 360°, division 2°, Ø angle scale: 67mm, angle pin length: 100/50mm

magnetic, quick and easy way to measure unevenly shaped surfaces with accuracy e.g. body parts from paper or metal

to control the oil pressure, 11 bar / 160 psi, with quick coupling, 12 pieces
The connection take place instead of the oil pressure switch. The measure result you can read on the manometer with double scale and rubber protection.

Consisting of:
oil pressure tester
connectors:
M10 x 1
M12 x 1,5
M14 x 1,5
M16 x 1,5
M18 x 1,5
1/4 x 18 NPT
1/8 x 27 NPT
1/2 x 20 UNF
3/8 x 20 UNF
1/8 DIN
90° angle adapter

suitable for DOT3, DOT4, DOT5.1
Checks the condition of the brake fluid according to the boiling point measurement method. The tester is connected with pole terminals directly to the vehicle battery.

Technical data: work light on the device, power supply: 12V (DC), test time: approx. 15 - 25 s, measuring range: 0 - 320°C, display: LCD with background light, K-sensor connection possibility for temperature measurement
Scope of delivery:
1 x tester SP1
1 x sample beaker
1 x dosing syringe
1 x manual SP1
1 x device case

for diesel engines, 8 - 40 bar
Comparison measurement of pressure conditions in the combustion chamber of diesel vehicles. Card with wide scale. Each card allows up to 8 checks
scope of delivery: 50 cards, connection adapter M14x1,5, M12x1,5, 1/4", heater plug adapter, injection nozzle adapter, in case

low pressure/vacuum pump, PVC, up to max. -1000 mbar, to control and adjust negative pressure operates functions at the vehicle

pressure/vacuum pump, metal, max. vacuum: -1000 mbar, max. pressure: 4000 mbar
To control and adjust pressure and low pressure operated function at the vehicle. Metal pump with integrated combined change-over and drain valve.

ignition gun with adjustment angle indicator
For regulating the ignition timing. With introduce measurement magazine, which shows the introduction of the ignition timing in degree. Impulse absolution by the ignition cable with the inductive-trigger clamp (#9983101). The device is powered by the 12 Volt car battery.

Consisting of a set of one pair test clamps with turn able, nickel gripping nipper and flexible shaft, test points with elastic isolated case and 7mm stainless steel point, surrounded isolated clamps
2 test lines, each 1m, plug with cage spring

digital, 600A AC/DC
equipped with A AC / A DC-, A DC-zero position and relative function

Technical data:
V DC: 0 - 240 mV, 0 - 600 V
VAC: 0 - 600 V
resistor: 0 - 24 M Ohm
frequency: 50 Hz - 100 kHz
current: AC / DC 0 - 240 A, 0 - 600 A