for fitting front, rear and side windows, 5x cartridge set
Suitable for all vehicle types. With one-component, high-modulus polyurethane adhesive and sealant. Suitable for aerials, fast curing, ready to drive at 22°C after 2 hours. TÜV crash-tested.

2-component adhesive and color detergent
LOCTITE 2-component adhesive "3090"
universal use, high-strength and gap-bridging, gel-like adhesive, 10g cartridge
gap-bridging up to 5mm, wide adhesion spectrum, suitable for metals, most plastics (not suitable for PE, PP and PTFE), rubber, wood, paper and leather
PERSIL color detergent "DUO CAPS", deep clean technology, 16 wash loads
Removes most stubborn stains and at the same time provides freshness and care in just one cap. Active stain remover for the most stubborn stains and Persil luminosity formula for radiant cleanliness.

Oxim silicone, room temperature curing (RTC), permanently elastic, temperature resistant, 1-component
For sealing valve covers, oil and transmission oil pans, water and oil pumps, differential, transmission, thermostat and control housings, axle covers, flange connections, headlights, taillights, battery boxes, etc. The mass hardens due to the reaction with atmospheric humidity. Resistant to oil, grease, coolants, UV radiation, cold and hot water, salt water, cleaning agents, weak acids and alkalis, etc.

for large-area bonding of foam rubber, vinyl, carpet floors etc. in vehicles
Universal spray glue with adjustable spray head. Correctable, temperature resistant from -30 to +80°C, plasticizer resistant and does not attack cured paint. Drying time: 2 - 4 minutes

spreadable, restores the factory original brush stroke, quick drying, grey
Especially for sealing trunk floors, floor panels, filler neck, door frames, wheel arches, spray walls, etc. Can be used on bare metal, primed and painted surfaces. Adhesion even on slightly soiled surfaces, not drained and is with all commercially available coatings after 30 min. overpaintable.

preformed round cord, permanently elastic, temperature resistance from -30°C till +90°C
Detachable connection for direct bonding of car windows without profiled rubber or to reduce vibrations and rattling noises in the vehicle. Can be glued directly into the application zone and has a high instant adhesion. Achieves excellent adhesion to glass and metal even without long curing of the adhesive.

permanently plastic, solvent-free sealant, max. sealing gap 0,2mm, green
Due to its thermal and chemical resistance, it is particularly suitable as a universal seal for demanding sealing joints and applications for easy disassembly. One-component, high-viscosity, polyurethane-based, resistant to mineral oils (also with additives), synthetic oils, lubricating greases, coolants, cold and hot water, salt water, detergents, weak acids and alkaline solutions, fuel. Possible applications: sealing caps, oil pans, water and oil pumps, differential housings, transmission housings, thermostat housings, control housings, axle covers and flange connections.

permanently elastic sealant, red
With particularly good adhesion on all metals. Seals reliable leaks from inside and outside and saves time-consuming dismantling. Temperature resistance from -60°C till +300°C (to 24h up to +315°C)

for individual sealing, to use in e.g. engines, transmissions, axles and auxiliary units

consisting of:
gasket paper: 6 sheets with 210 x 300mm
NBR bonded cellulose fibre (Abil N), till max. +120°C: 1x 0,25mm, 1x 0,50mm, 1x 0,75mm, 1x 1,00mm
NBR bonded, synthetic organic fibre (EWP 207), till max. +200°C: 1x 0,75mm
NBR bonded Aramid fiber with a sheet metal insert made of perforated sheet steel (FW 522), till max. +250°C: 1x 1,25mm

PTFE threaded sealing tape (teflon tape), white
high performance tape, 100% PTFE, DVGW-NV-5143, DIN EN 751-3, class FRp (for fine thread till DN10)