YUASA Battery 53030
Yuasa, standard
- Article number: 05407960
- Original number: 53030-DC
ETN: 530 030 030
DIN: 53030
Standard batteries are dry pre-charged, fill the battery with the acid before use and leave open for approx. 1-2 hours, then attach bleeder hose and connect the battery.Attention: by batteries from 12V evtl. must be recharged!
Product information
- Bleeding: right central
- Capacity 20 Hr: 30.0 Ah
- Cold start current CCA: 180 A
- Design: standard , without acid pack
- Filling quantity: 1.6 l
- Height: 171.0 mm
- Length: 186.0 mm
- Minus pole: front left
- Plus pole: front right
- Range of application: motorcycle
- Type: Article
- Voltage: 12V
- Width: 130.0 mm
- Supplier Article Number:: 53030-DC
- EAN: 5050694004919
- MSRP: €145.00
- Brand/Supplier YUASA
- Unit of measure: PIECE
| Article | Price | |
|---|---|---|
 BAAS Disconnect Switch "BA18" switch incl. cable
| ||
 BS-BATTERY battery charger "BS15" 12 Volt
| ||
 BS-BATTERY Battery Charger "BS10" 6V/12V
| ||
 BS-BATTERY Battery Charger "BS60" 12 Volt
|
| Article | Price | |
|---|---|---|
 Battery "G12-30" Exide, gel, sealed Solves the problem of potential leaks from a conventional battery. The electrolyte (acid) completely exists of a non-liquid gel. Even in case of battery housing damage the electrolyte can not run out. There is an ultimative protection against possible damages by acid in the motorcycle or scooter.The life span of a gel battery is approx. 50% higher thana customary MTF battery. According to JB/4282-92 standard, a standard MTF battery reaches a service life of up to 200 cycles. Up to 500 cycles a gel battery.Attention: Recharge only with suction. "Intelligent device" as Optimate 4 and Intellicharger II. Damages by wrong loading are not covered by the guarantee!Attention: This sealed (gel) batteries never open, drill or remove sealing bar!
|
Product variants
Using the search field, you can refine the selection of product variants.
| Article | Price | |
|---|---|---|
 YUASA Battery 53030 Yuasa, standard Standard batteries are dry pre-charged, fill the battery with the acid before use and leave open for approx. 1-2 hours, then attach bleeder hose and connect the battery.Attention: by batteries from 12V evtl. must be recharged!
|