MIG-MAG gas-shielded welding machine, three-phase, synergic controlled, with many accessories
Suitable for welding work in locksmith shops and automotive workshops. The wire feed unit can process 2 wire types and diameters. This avoids a loss of time when changing wire. The first wire feed unit is integrated in the unit and the second is located in a separate wire feed case, which is connected via an intermediate hose package. 2 torches enable selection of wire feed unit and control of welding parameters (gas among others). 2 electrovalves on the rear side of the unit enable the supply of 2 different gases. No need to change wire spools, wire guide roll and contact tubes. The plant can be used variably. It is suitable for welding steel, stainless steel and aluminum.

electronic, fuse T3 / 15 A, supply voltage 12 / 24 V, with reverse polarity protection
To protect the on-board electronics of vehicles from voltage peaks / defects, e.g. due to welding work on the bodywork without disconnecting the battery. The voltage peaks are permanently absorbed and suppressed. It also prevents damage to the on-board electronics when charging or bridging the installed battery. The device is easy to operate. A red LED indicates active overload protection and an acoustic signal sounds in the event of voltage peaks. Connection to the battery is made via two standard crocodile clips.